Características:
 
 
Formulários:
 
 
 
 
 
 
RSPD-01C120-XX
155Mb/s 120km CWDM SFP Transceiver
Hot Pluggable, Duplex LC, +3.3V, 1270nm~1610nm, CWDM DFB-LD, Single-mode, DDM
 
 
 
 
 
 
Description:
FIBERWDM’s RSPD-01C120-xxTransceiver is a high performance, cost effective module which have a duplex LC optics interface. Standard AC coupled CML for high speed signal and LVTTL control and monitor signals. The receiver section uses a PIN receiver and the transmitter uses a 1270nm~1610nm CWDM DFB laser, up to 29dB link budge ensure this moduleSONETOC-3/SDHSTM-1 120km application.
Absolute Maximum Ratings
|   Parameter  |  
           Symbol  |  
           Min.  |  
           Typical  |  
           Max.  |  
           Unit  |  
        
|   Storage Temperature  |  
           TS  |  
           -40  |  
           
  |  
           +85  |  
           °C  |  
        
|   Supply Voltage  |  
           VCC  |  
           -0.5  |  
           
  |  
           4  |  
           V  |  
        
|   Relative Humidity  |  
           RH  |  
           0  |  
           
  |  
           85  |  
           %  |  
        
Recommended Operating Environment
|   Parameter  |  
           Symbol  |  
           Min.  |  
           Typical  |  
           Max.  |  
           Unit  |  
        |
|   Case operating Temperature  |  
           Industrial  |  
           TC  |  
           -40  |  
           
  |  
           85  |  
           °C  |  
        
|   Extended  |  
           -5  |  
           
  |  
           85  |  
           °C  |  
        ||
|   Commercial  |  
           0  |  
           
  |  
           +70  |  
           °C  |  
        ||
|   Supply Voltage  |  
           VCC  |  
           3.135  |  
           
  |  
           3.465  |  
           V  |  
        |
|   Supply Current  |  
           Icc  |  
           
  |  
           
  |  
           300  |  
           mA  |  
        |
|   Inrush Current  |  
           Isurge  |  
           
  |  
           
  |  
           Icc+30  |  
           mA  |  
        |
|   Maximum Power  |  
           Pmax  |  
           
  |  
           
  |  
           1  |  
           W  |  
        |
Electrical Characteristics(TOP =-40 to85°C, VCC = 3.135 to 3.465 Volts)
|   Parameter  |  
           Symbol  |  
           Min.  |  
           Typical  |  
           Max.  |  
           Unit  |  
           Note  |  
        
|   Transmitter Section:  |  
           
  |  
        |||||
|   Input differential impedance  |  
           Rin  |  
           90  |  
           100  |  
           110  |  
           W  |  
           1  |  
        
|   Single ended data input swing  |  
           Vin PP  |  
           250  |  
           
  |  
           1200  |  
           mVp-p  |  
           
  |  
        
|   Transmit Disable Voltage  |  
           VD  |  
           Vcc – 1.3  |  
           
  |  
           Vcc  |  
           V  |  
           2  |  
        
|   Transmit Enable Voltage  |  
           VEN  |  
           Vee  |  
           
  |  
           Vee+ 0.8  |  
           V  |  
           
  |  
        
|   Transmit Disable Assert Time  |  
           Tdessert  |  
           
  |  
           
  |  
           10  |  
           us  |  
           
  |  
        
|   Receiver Section:  |  
           
  |  
        |||||
|   Single ended data output swing  |  
           Vout,pp  |  
           300  |  
           
  |  
           800  |  
           mv  |  
           3  |  
        
|   Data output rise time  |  
           tr  |  
           
  |  
           
  |  
           500  |  
           ps  |  
           4  |  
        
|   Data output fall time  |  
           tf  |  
           
  |  
           
  |  
           500  |  
           ps  |  
           4  |  
        
|   LOS Fault  |  
           Vlosfault  |  
           Vcc – 0.5  |  
           
  |  
           VCC_host  |  
           V  |  
           5  |  
        
|   LOS Normal  |  
           Vlos norm  |  
           Vee  |  
           
  |  
           Vee+0.5  |  
           V  |  
           5  |  
        
|   Power Supply Rejection  |  
           PSR  |  
           100  |  
           
  |  
           
  |  
           mVpp  |  
           6  |  
        
Note:
1. AC coupled.
2. Or open circuit.
3. Into 100 ohm differential termination.
4. 20 – 80 %
5. LOS is LVTTL. Logic 0 indicates normal operation; logic 1 indicates no signal detected.
6. All transceiver specifications are compliant with a power supply sinusoidal modulation of 20 Hz to 1.5MHz up to specified value applied through the power supply filtering network shown on page 23 of the Small Form-factor Pluggable (CWDM SFP) Transceiver Multi-Source Agreement (MSA), September 14, 2000.
Optical Parameters (TOP =-40 to85°C, VCC = 3.135 to 3.465 Volts)
|   Parameter  |  
           Symbol  |  
           Min.  |  
           Typical  |  
           Max.  |  
           Unit  |  
           Note  |  
        
|   Transmitter Section:  |  
        ||||||
|   Center Wavelength  |  
           λc  |  
           λ-6  |  
           λ  |  
           λ+7.5  |  
           nm  |  
           
  |  
        
|   Spectral Width  |  
           σ  |  
           
  |  
           
  |  
           1  |  
           nm  |  
           
  |  
        
|   Optical Output Power  |  
           Pout  |  
           0  |  
           
  |  
           5  |  
           dBm  |  
           1  |  
        
|   Optical Rise/Fall Time  |  
           tr / tf  |  
           
  |  
           
  |  
           500  |  
           ps  |  
           2  |  
        
|   Extinction Ratio  |  
           ER  |  
           10  |  
           
  |  
           
  |  
           dB  |  
           
  |  
        
|   Generated Jitter (peak to peak)  |  
           JTXp-p  |  
           
  |  
           
  |  
           0.07  |  
           UI  |  
           3  |  
        
|   Generated Jitter (rms)  |  
           JTXrms  |  
           
  |  
           
  |  
           0.07  |  
           UI  |  
           3  |  
        
|   Máscara de Olho para Saída Óptica  |  
           Compatível com G.957 (segurança de laser classe 1)  |  
           
  |  
        ||||
|   Seção do receptor:  |  
           
  |  
        |||||
|   Comprimento de onda de entrada óptica  |  
           λc  |  
           1260  |  
           
  |  
           1620  |  
           nm  |  
           
  |  
        
|   Sobrecarga do Receptor  |  
           polo  |  
           -8  |  
           
  |  
           
  |  
           dBm  |  
           4  |  
        
|   Sensibilidade RX  |  
           sen  |  
           
  |  
           
  |  
           -34  |  
           dBm  |  
           4  |  
        
|   RX_LOS Afirmar  |  
           LOS A  |  
           -47  |  
           
  |  
           
  |  
           dBm  |  
           
  |  
        
|   RX_LOS Desafirmar  |  
           LOS D  |  
           
  |  
           
  |  
           -37  |  
           dBm  |  
           
  |  
        
|   Histerese RX_LOS  |  
           PERDER  |  
           0,5  |  
           
  |  
           
  |  
           dB  |  
           
  |  
        
|   Especificações Gerais:  |  
        ||||||
|   Taxa de dados  |  
           BR  |  
           
  |  
           155  |  
           
  |  
           MB/s  |  
           
  |  
        
|   Taxa de erro de bit  |  
           BER  |  
           
  |  
           
  |  
           10-12  |  
           
  |  
           
  |  
        
|   máx. Comprimento de link suportado em 9/125μmSMF@155Mb/s  |  
           LMAX  |  
           
  |  
           80  |  
           
  |  
           km  |  
           
  |  
        
|   Orçamento total do sistema  |  
           LIBRA  |  
           29  |  
           
  |  
           
  |  
           dB  |  
           
  |  
        
Observação
1. A potência óptica é lançada no SMF.
2. 20-80%.
3. Medições de jitter feitas usando Agilent OMNIBERT 718 de acordo com GR-253.
4. Medido com PRBS 27-1 em 10-12 BER
 
 
Dimensões Mecânicas
 
  
 
  
Desenho mecânico
 
 
Informações do pedido:
No Part No. ofRSPD-01C120-xx,xx significa comprimento de onda central, como:
27: para 1270nm, 29: para 1290nm, 31: para 1310nm,……61: para 1610nm.
 
 
 
 
 
 
Quer saber sobre este produto?
Se Você está interessado em nossos produtos e quer saber mais detalhes, por favor, deixe uma mensagem aqui, vamos responder você assim que nós puder.